Go to the Fritzspeakers.com Home Page

This FRITZSPEAKERS single driver model features the Fostex FE167E, a 6
inch Banana fiber cone full range driver that delivers a dynamic robust
and engaging sound from below 45Hz in most rooms all the way up past
20kHz. They are a crossover-less high efficiency design @ 94 db
sensitivity. The loudspeaker enclosures are fine furniture grade
quality cabinets handcrafted in my shop. They are a bass reflex design
with the port on the front or the back and are properly tuned for this
driver. Available in your choice of my standard wood finishes- Cherry,
Maple, Mahogany, Oak, Walnut or Rose Walnut & they can be ordered in a
wide selection of other woods & finishes at additional cost. Check out
my Custom Finishes page on my web site for more ideas about what is
available.

They are shielded so they can be used near tv, computer & audio
equipment. These work and sound great with low powered tube amps-
Push-Pull & Single-Ended Triodes, Gainclone & Tripath amps such as the
Trends, Little Dot & Sonic Impact T-amps. They also work equally well
with higher powered & older vintage Stereo & modern Surround Sound Home
Theater amps & receivers, just be careful not to play them too loud!

The drivers are wired up and Silver soldered with Canare wire. The
terminal connectors are all brass gold plated binding posts and will
accept spades, banana plugs or 4 AWG wire.

Thanks & Happy listening... Fritz Heiler

FRITZSPEAKERS FOSTEX 6 FULL RANGE SPECIFICATIONS:

$750.00/pair

Frequency Response: <45Hz to 22kHz
Design: Single driver, front or rear ported bass reflex
Driver: 6 inch Fostex FE 167E Banana plant fiber cone
Sensitivity: 94 dB
Nominal Impedance: 8 ohms
Recommended Power: 5-60 Watts RMS
Dimensions: 18H x 8W x 11.5D
Weight: 22 lbs. each

Go to the Fritzspeakers.com Home Page

Fostex 4 1/2" Full Range

$700.00/pair

This FRITZSPEAKERS single driver model features a Fostex 4 1/2 inch Banana fiber cone full range driver that delivers a dynamic robust and engaging sound from 55Hz in most rooms all the way up past 17kHz.  They are a crossover-less high efficiency design @ 91 dB sensitivity FE127E or 93dB for the FE126E.  The loudspeaker enclosures are fine furniture grade quality cabinets handcrafted in my shop and are a bass reflex design properly tuned for this driver following Fostex recommendations.  These have a large flared port with a 1 inch radius to eliminate vent noise 

The FE127E is shielded so they can be used near tv, computer & audio equipment. These work and sound great with low powered tube amps- Push-Pull & Single-Ended Triodes, Gainclone & Tripath amps such as the Trends, Little Dot & Sonic Impact T-amps.  They also work equally well with higher powered  & older vintage Stereo & modern Surround Sound Home Theater amps & receivers, just be careful not to play them too loud!

The drivers are wired up and Silver soldered with Canare wire.  The terminal connectors are all brass gold plated binding posts and will accept spades, banana plugs or up to 4 AWG wire.  I have a money back guarantee (less shipping) if you are not absolutely delighted with the performance of my loudspeakers in your system.   

FRITZSPEAKERS FOSTEX 4 1/2 FULL RANGE SPECIFICATIONS:

Frequency Response: 55Hz to 17kHz
Design: Single driver, rear ported bass reflex
Driver: 4 1/2 inch Fostex  Banana plant fiber cone
Sensitivity: 91 dB Shielded FE127E,  93 dB FE126E
Nominal Impedance: 8 ohms
Recommended Power: 5-60 Watts RMS
Dimensions: 14H x 7 1/2W x 11 1/2D
Weight: 17 lbs. each    Shipping weight is 42 lbs. per pair